Posts By: admin

Pull Servo Connector Out Of Receiver

Pulling connectors out of the receiver can be a real pain. If you pull the wires you might damage the connector. Instead, get an old pair of tweezers or fine tipped pliers and bend the end 90 degrees. This lets you grab the connector and pull it out easier.

I don’t usually bend my pliers, but you may want to.

Keep Servo Extensions Connected

To hold servo/battery connectors together, use a piece of dental floss or fishing line and wrap it around the connectors looping it through the wire so it pulls the connectors together. Tie it with a good knot that won’t slip undone. If you’re unsure of your knot, just put a drop of super glue on it when you’re done.

Thread Wire through Antenna Tube

To make routing your antenna wire through the antenna tube, first run some dental floss or fishing line through it. Then you can tie it to the wire about an inch from the end and pull it through.