Save those Tic-Tac containers! You can tape a group of them together for a nifty storage bin.
Posts By: admin
Clean Your Transmitter
Keep your transmitter clean and free of dust and oil. The oil can cause the chrome to come off or
become pitted and dust just looks bad. A toothbrush works perfectly for cleaning out the small crevices.
Extend Your Transmitter Antenna
Anytime you turn on your transmitter, the antenna should be fully extended to prevent the internal electronics from overheating or becoming out of tune.
Waterproof Your Electronics Without Silicone
Waterproofing your batteries and receiver should be done with balloons and rubber bands. Some tape around the Rx case helps seal the halves together. Never use Silicone sealant for sealing your gear as the fumes released during curing will eat copper!
Antenna Wire Wrap Up
Your receiver antenna wire is a finely tuned part of the radio system. To keep your radio at peak performance and to maintain proper range, never cut the wire shorter. You can wrap it around a piece of lexan to take up the slack, but don’t wrap it over itself as this can cause glitching and loss of range.
Also, never wrap the excess hanging out of your antenna tube around the tube as this will cause problems too. A few small pieces of fuel line will hold it tight against the tube so you can run it straight down the tube and keep it from flapping in the breeze. For more permanent set-ups, heat shrink tubing works great and provides additional protection during crashes.